Blogs

Replacing Garage Door Cables

on September 15 at 09:45 PM

Your garage door cables are also referred to as torsion springs. This confuses many customers, because experts may make reference to the component as a spring or perhaps a cable.

 

In actuality, it is not a spring until it is wound around the shaft. Before the winding is complete, it is a cable. So, I suppose you may say that both terms are correct.

 

Although each cable is (or should be) made of a strong steel wire, one can break as the years go by. The average life expectancy of a cable is between three and seven years. The variance depends on how many times the doors are opened and closed. For this reason some homeowners only open or close them if it is absolutely necessary.

 

When one cable breaks, you are able to expect one other to break in a comparatively little while of time. For this reason you typically purchase them in pairs. It really is practical to replace them both at the same time frame, because the job is tedious and can be dangerous.

 

Since the springs are under high tension, it is very important to see this task as hazardous. If you are not really acquainted with the various tools, you are better off calling a professional.

 

The springs are dangerous once they break, too. Luckily, they often break through the closing operation, as opposed to the opening. When someone is inside, there is a chance that the loose bit of cable will hit them. Some manufacturers install safety mechanisms to hold that from happening.

 

If you choose professional garage door cable replacement is something you are able to handle by yourself, you will need to measure the prevailing cable. The most typical lengths are 7 and 8 feet, although an older style or defunct manufacturer might have supplied something different.

 

It could be difficult or even impossible to gauge the broken cable. You are able to always find out which length to order by calling the original manufacturer, if they're still in business. The information are often available online.

 

Before you install the new cable, you will need to remove the prevailing spring. You can find special tools designed especially for that purpose. The task involves cutting the spring or unwinding it.

 

When the old springs are off the shaft, you will need to wind the new garage door engineers cables around it. This really is accomplished using the winding cone. The cable must be wound in the proper direction. Otherwise, the springs should come loose from the cones.

 

The winding bars can slip from the cones if you are not careful to be certain they are fully inserted. This happens even to professionals. Even though the more knowledgeable professional can replace the springs in what appears like no time at all, everyone has trouble using them sometimes.

 

Most professionals stretch the springs after the winding is complete to make sure that the shaft floats freely. You may also need to stretch and test the springs to make certain that your installation was done correctly.

 

If the springs bind or catch, your doors will not close completely. It may be required to demand help even when you have done your absolute best with the new garage door cables. It's nothing to be ashamed of. It happens to the very best of us.

Comments (0)